Hello,
I have a question regarding our Matsuura LX-0 with the L-Tech 15i control. I am wanting to program an interpolation of a circle at the most highest accuracy possible using hpcc (AiCC) G05.1 Q1 R1. Listed below is an example of what we are currently doing. Is there a better way of doing this? Like programming the circle in quadrant's instead of full circle? Or arc in at a 45 degree instead of 0 or 90 degrees? Program using NUMBRS? Were getting a little to much out of roundess. The part itself is a casting with an partial opening on the pocket circle which I am arcing in at and out to prevent any "bumps". Our main goal is to achieve the most circular round part as possible with minimal runout. Thank You for your time.
%
T1M6
G0G90G54X0Y0M3S30000
G43H1Z1.0M8
G05.1Q1R1
G1Z.1F200.
Z-.5F100.
G91G1G41D1X-.1Y-.1F120.
X-.1Y-.1
G3X.2Y-.2I.2J0
G3X0Y0I0J.4
G3X.2Y.2I0J.2
G0G90G40X0Y0
G0Z3.0M9
M5
M30
%