At the BBQ i remember someone talking about some 'wrapper' software for 4th axis machining that takes into account the Z depth. (i think it may have been Greolt?)
Does anyone know the program? Anyone had any experience with it?
Cheers
Matt
At the BBQ i remember someone talking about some 'wrapper' software for 4th axis machining that takes into account the Z depth. (i think it may have been Greolt?)
Does anyone know the program? Anyone had any experience with it?
Cheers
Matt
Hi Matty,
You will have to go to vectric http://www.vectric.com/forum/viewtopic.php?t=2920
Should be what you want
Cheers, Bob
http://www.ocm.com.au/wordpress/
Greolt has used it and had good results
Cheers, Bob
http://www.ocm.com.au/wordpress/