[oncoarse]

I'm brand new to CNC and I have just bought a CNC router for my school woodwork room. I have imported it from China and it's an XJ6090 from XYZ-Tech http://www.xyz-tech.com/listcp.asp?b...l=16&proid=111. Ok, I know you will say "you get what you paid for" but budgets in schools are limited and a Roland MDX or similar was completely out of the question. So, it was this or nothing, really. I'm sure it will be great for our purposes, but I am finding out (as I suspected) that the after sales backup leaves a lot to be desired. So my question is, is there anyone out there in Melbourne operating a similar CNC router, probably with Mach 3 software that I come and have a look at? I live in North East Melbourne but I would be prepared to travel to get a first hand look at the setup. I'm getting impatient, I want my students to get the benefit of CNC for their woodwork projects.

[Greolt]

I'm in Geelong if that is any help.

Greg

[oncoarse]

Sounds like a fishing trip Greg. I'll get back to you, thanks a lot.
John

[crocky]

Hi John,

I am at Hoppers Crossing near Werribee if thats any good

[oncoarse]

That's a lot closer Bob. Thank you, I'll get back to you if there's no-one closer. I really appreciate your reply.
John

[mac simpson]

i bought my cnc router from qld it runs on mach3 i am
haveing no luck in runing it i might be sum help to you
i have all books on mach3
i live in melbourne ..grantville my email [email protected]
5/11/08 from mac

[Greolt]

Mac are you offering assistance or asking for help?

A long time ago I used to spend a bit of time in Corrinella. Had a girlfriend there.

Greg

[mac simpson]

hi greg i might be able to help you out with
some of question . i am haven a rest from it
for a time from mac grantville 6/11/08