Hi from Germany
i got a problem with the toolchange position !
where can i change the position for the toolchange when i use buildin PLC canned Cycles
Programm 3-Part4
1 Zylindercycle
2 Zylindercycle
3 treadcycle
wher can i set there the toolchange position
the manuel say you need to edit the sub programm
wher is P60 my parametertable starts on P100
is this the right way to do this?
P60 "TOOLSUB"-> P60 "TOOLSUB" = 55
programm 99999997
(SUB 55)
(P100 = NBTOOL)
(P101 = MS3)
G0 G53 XP?? ZP?? where ?? are the numbers from the reference point
M5
M0
(RET)