Putting together a 3 axis gantry mainly for engraving. Mach4(demo), ESS, Gecko drives. Got motors tuned & calibrated but when I try to load any of the demo gcode files I get
"a macro failed to compile while loading"
What am I missing?
Thanks
cncneon
Putting together a 3 axis gantry mainly for engraving. Mach4(demo), ESS, Gecko drives. Got motors tuned & calibrated but when I try to load any of the demo gcode files I get
"a macro failed to compile while loading"
What am I missing?
Thanks
cncneon
Try redownloading and reinstalling the Mach4 software; it sounds like something got corrupted.
would you install over the existing copy or do an uninstall, clean registry, then a fresh install?
And how about the ESS, fresh install on it also?
Also my profile, should I save it or start afresh?
cncneon