Hi All
I have just built a cnc router table and I am using Mach3 and ESS. Also on my computer I have Fusion 360 (free) which I am currently learning.
The problem I have is that my ethernet adapter is configured to talk to the ESS but, as you know Fusion 360 requires the internet to operate.
If I unplug the ESS and plug in the internet to use Fusion 360, the network adapter does not allow connection with the internet as it is configured to communicate with the ESS.
I can re-config the adapter each time I use Fusion then run the Warp9 ESS config again but it is time consuming. i am sure there is an easier way.
I don’t intend running fusion 360 or any other web programs while using Mach3.
My question is, can I set up 1 network adapter for ESS and a separate network adapter for the internet so I can switch between the two.
Any help on this problem would be greatly appreciated.
Regards
John
Perth, Western Australia