It is easy to change the Post Processor to output a different named Machine File, I have a few that I named to suit the actual machines I use in the shop.
For example I have an old Bridgeport 412 VMC and I simply copied a template and saved it out under the name "BRIDGEPORT_412".
I have attached the Template and it`s associated Reverse Post file in a Zip file for you.
Open the Zip and simply copy and paste the files into the following folders:-
The Machine file goes in the
C:\Program Files\Predator Software\Common Files\Machines folder on your PC.
The Reverse Post file goes in the
C:\Program Files\Predator Software\Common Files\RPost 7.0\Mill folder on your PC
Once you have the Machine file in the folder just navigate to the file and right click and then select "re-name" and make the name of the file EXACTLY the same as the Machine file line in your header, eg
3AXVMILL_MM, then when you open the Predator Editor 2 you should be able to go to the drop down list and find the
3AXVMILL_MM listed there.
With a bit of luck that should work for you, it works fine here
With a bit more luck you may find that from then on whenever you open the Predator Editor it will default to that template for you
Regards
Rob
:rainfro::rainfro::rainfro:
.