[dm.mcgahee]

I am a high school shop teacher trying to revive a Spectralite benchtop mill.
Anyone have the correct settings (baud rate, parity, etc.) to "send" code to a Spectralite benchtop mill? I also could use some help in finding some control software for the same machine. The BobCad sales rep told me the software package had everything necessary to operate this mill. It generates code just fine but I don't see a control panel to operate the mill, move axis' manually, etc.

Any help would be appreciated.

Dennis
[email protected]
707 332 4509

[MikeTheG]

bobcad is not a control software , you will still need to have a software such as mach3 for example to control the machine, if you have a controller on the machine you can send the programs to the control through bobcad but it doesnot have a control pannel.