I just replaced my c10 breakout board with a c11g after a power surge blew my c10.
Everything is running good, excep at the end of a program. Every time it finishes running a program, as the z axis starts moving up, the steppers all stall and miss a bunch of steps.
All other times it runs fine. It jogs fine, all axis run good, programs run fine, its just squeels and misses steps on all 3 axis when it ends a program.
I ran 8 programs today, 30 min to an hour each, and finished my parts but kept having to rezero with edge finders every time a program ended.
Anyone seen this before? Any ideas?