Hello ,
Can someone tell me if I can remove the part shown below in the picture? I unscrewed the bolt perpendicular to it, but it still seems very snug in there. I want to mount some linear encoders on the x-axis table, but this obviously foils my plans. Am I not pulling hard enough? Is it a press-fit or something?
If it's function is important, can I mill it down to clear the area where I want to mount the rails?
Thanks very much all,
Steve
Results 1 to 20 of 22
Threaded View
-
08-22-2007, 02:44 AM #1
Registered
- Join Date
- Jan 2007
- Posts
- 65
Weird Seemingly useless part on CNC Taig Mill, Can I remove this? (pic)
Reply With QuoteSimilar Threads
-
how to remove chuck from Taig rotary table?
By dwneumann in forum Taig Mills / LathesReplies: 11Last Post: 11-15-2012, 11:04 AM -
Mill with tapered chuck seems useless
By slcoleman in forum Benchtop MachinesReplies: 5Last Post: 11-02-2010, 05:47 PM -
Can this part be cut on a Taig CNC mill with a 4th axis?
By drclawscat in forum Taig Mills / LathesReplies: 7Last Post: 10-06-2010, 08:05 PM -
Found a useless part on my SX3
By Rainman229 in forum Syil ProductsReplies: 3Last Post: 09-23-2009, 10:05 PM -
Weird Z problem on the taig mill
By sp1nm0nkey in forum Taig Mills / LathesReplies: 5Last Post: 12-17-2007, 11:35 AM
Posting Permissions
