[shaunbirm]

Hi All,

Does any of you lot use Xilog or Xilog plus.
If you need any help just give me a shout regarding Xilog or Xilog plus.

Also I have an alphacam post processor for the NUM 720, NUM 750, also for the RECORD 220 I have two post procesors.

You might need to tweek them.

Shaun

[branchy]

Hi All,

Does any of you lot use Xilog or Xilog plus.
If you need any help just give me a shout regarding Xilog or Xilog plus.

Also I have an alphacam post processor for the NUM 720, NUM 750, also for the RECORD 220 I have two post procesors.

You might need to tweek them.

Shaun

Hi Shaun,
Do you drip feed to your SCM? I have a Record 2 and am using Ezcam Software. I can send files no problem at all but drip feed has been ongoing issue for the past 12 months. if you have any advice I would be most appreciative.
Cheers
Chris

[shaunbirm]

Hi Chris,

I don't use drip feed.
The programs i use are stored on a server called (k drive).

I don't store any programs on the control.

When the programs are opened up in panel mac and run they are actually all still on the server and the programs run fine.

To do this all you need to do is put your control on the network and access is dead simple

If you need more info let me know and I'l do a demo.

Shaun.

[alanhende]

Hi Shaun,
I am working on a Record 220 & would certainly like an Alphacam post if you still have one.

Thanks

Alan

[MLEDWARDS]

Hi Shaun/All

I appreciate this tread is rather old but I've just bought a SCM Record 1 and require an Alphacam post processor for the NUM 720, is that something you can still help with!?

Thanks

M

[Woodcreations]

Hi all

Also just recently purchased a SCM Record 1 num 720 and be grateful for any manuals, posts or advice with this machine.

Also we can not work out were the c1m1 wire at the back goes, so any wiring diagram be most helpful....

Thanks for any help.....

[email protected]

[MLEDWARDS]

Hi all

Also just recently purchased a SCM Record 1 num 720 and be grateful for any manuals, posts or advice with this machine.

Also we can not work out were the c1m1 wire at the back goes, so any wiring diagram be most helpful....

Thanks for any help.....

[email protected]

Hi
What NUM 720 do you have? ie B, F etc? I have a spare manual for a NUM 720F, I had two come with my machine which is bit baffling as my controller is a 720B! Welcome to it thou.

Martyn

[Woodcreations]

Have error message N3 axes at limit switch...

Does anyone know how to sort this? thanks