587,790 active members*
3,982 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Mach Software (ArtSoft software) > Mach Mill > Circle artifacts coming up on Mach3 after using waterline in MeshCAM

Thread: Circle artifacts coming up on Mach3 after using waterline in MeshCAM

Results 1 to 3 of 3
  1. 07-12-2013, 11:56 PM #1
    *Jupiter*
    *Jupiter* is offline Registered
    Join Date
    Jul 2013
    Posts
    3

    Circle artifacts coming up on Mach3 after using waterline in MeshCAM

    I am using MeshCAM, and when I use waterline I keep getting these artifacts that show up on Mach5 when I go to cut. I tested the code in CutViewer and they aren't there, but it only happens after using waterline.Attachment 191872

    Thank you for ideas or solutions.
    Reply With Quote Reply With Quote
  2. 07-13-2013, 01:05 AM #2
    ger21
    ger21 is offline Community Moderator
    Join Date
    Mar 2003
    Posts
    35538
    Change your IJ mode in General Config to Incremental.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 07-17-2013, 05:29 PM #3
    *Jupiter*
    *Jupiter* is offline Registered
    Join Date
    Jul 2013
    Posts
    3
    Thank you! This worked perfectly!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Weird circle G03 in Rhinocam Mach3 inch post
    By btsioles in forum Rhinocam
    Replies: 5
    Last Post: 10-22-2014, 09:56 PM
  2. make a circle in the center of square from artcam to mach3
    By Eben Cheka in forum Mach Mill
    Replies: 3
    Last Post: 05-30-2013, 05:56 PM
  3. G03 command in Mastercam x4/Mach3 coming out odd
    By Spinnetti in forum G-Code Programing
    Replies: 4
    Last Post: 10-30-2012, 02:54 PM
  4. Tool Changes with MeshCAM and Mach3
    By ViperTX in forum Uncategorised CAM Discussion
    Replies: 5
    Last Post: 02-16-2011, 05:41 PM
  5. Having problems from Meshcam to Mach3
    By ClemsonGirl in forum Uncategorised CAM Discussion
    Replies: 3
    Last Post: 02-28-2007, 12:34 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules