I have a matched set of three fanuc red cap ac servo motors model 20s and a06B-6058-H006 amplifiers, as shown in the attached photos
I am not ready to spend the money for a full fanuc system, just yet.
I was wondering if there is any other kind of milling machine controller, like EMC or Mach that would work with suitable adapters.
This is for a newly built machine, so I am starting from scratch.
It would only have to work well enough for semi hobby use , with no tool changer or plc, for a couple of years until I am ready for an industrial duty upgrade.
I could get by with less than the full rated torque and still leave my options open for the future.
I have been studying the manuals and the hook up looks simple enough. The power supply is built in. there are three wires for power in, three wires for power out to the motor and a 20 pin honda connector.
I am not sure about the two middle wires marked 100b and 100a. I am guessing that they are for the command signal from the controller.
There are no potentiometers anywhere an the unit so I don't know how one would tune or adjust the parameters without a fanuc controller.