2) Onto the 3 Purple Axe faces. Since each "face" is a closed shape, I've omiited the rest of the axe. Done't need it to model and shape anyway (yet). I wanted to take three lines of differing elevations. Stacked over each other exactly. From Edge on, They look as 3 purple lines. Where I am stuck: I wanted to rotate the upper purple line from the edge up say 10' . The middle line stays as is. Then rotate the bottom line to -10'.
I end up w/ a "<" and 1 line "-" in the middle when looking edge on. then just LOFT it. but I'm not able to figure out how to get the 2d shape to act 3D (in a sense) from the edge on. This one, I am thinking is not really do-able? But thought I'd ask. I could then marry it to the .25 handle and head where they meet on -edge. Lopp off the excess... Or do the math and have them line up perfectlly.