Originally Posted by
monolithfs
I have a home made CNC plasma table. I saw the machine work before i broke it down for transport...the machine is now set-up at my shop. I can get it to run g-code on the x,y and z axis (z runs backwards). The problem I have is I can't figure out where to connect the control cable from the plasma torch so the torch knows when to fire on/off. The plasma torch is a Hypertherm 1000 G3 series....I have posted photos of the hardware, any help would be GREATLY APPRECIATED!!!!.....as a side note I'm creating my g-code in bobCAD and using the Mach3 controller, I'm open to suggestions if other software is better/easier?