Originally Posted by
HeissWelding
Hi, my name is Amanda. I'm the secretary here at Heiss Welding. And, we're having a problem with our Plasma Table. We're using a powermax1000 on a floating head. We're hooking up the height control now, and we ran into a problem. We've installed the Rev-01 Voltage divider in our Powermax1000, connected the THC Sensor PWM module between our Bladerunner Dragoncut and the powermax1000 as specified in the manual. However, when we go to test the torch firing circuit and press both torch fire buttons on the RAV-01 card we do not get an arc. We've checked the continuity, we're not getting any. We're not getting any signal to fire the torch. When we jumper-ed the torch it worked fine, but we're stumped. Any help would be appreciated.