We bought a used Citizen E32 (1986 machine) and are in the process of getting it set up. We are able to 'home' all the axes except the opposed toolpost (Y axis). When we move the tool post away from the turret we get an overtravel limit alarm at about the halfway point. There are 4 limit switches on the back but the 'actuators' are no where near tripping any of the switches. If anybody can help or offer suggestion it will be greatly appreciated! Thanx!
Results 1 to 3 of 3
-
09-20-2009, 10:53 PM #1
Registered
- Join Date
- Sep 2009
- Posts
- 5
Citizen E32 Opposed Tool Post overtravel
-
09-21-2009, 05:26 PM #2
Registered
- Join Date
- Feb 2008
- Posts
- 267
Your local Citizen dealer should be able and willing to help with this over the phone. NJ office is 201-818-0100
Good Luck.
-
11-24-2010, 04:12 PM #3
Registered
- Join Date
- Jul 2009
- Posts
- 8
Press & Hold CB/CAN button while jogging Y axis. Or while powering up machine press & hold CB/CAN button, this over-rides all soft overtravel alarms on 300 & 500 series Mitsubishi controls.
Reply With QuoteSimilar Threads
-
z-axis overtravel at tool change
By jam-man in forum OkumaReplies: 4Last Post: 11-12-2009, 04:19 PM -
WTB: Citizen Tool setter F25
By PixMan in forum Want To Buy...Need help!Replies: 0Last Post: 07-18-2009, 12:51 PM -
ElectroHead (opposed to PetrolHead) says hi!
By hrh in forum Community Club HouseReplies: 0Last Post: 01-03-2009, 04:41 PM -
Finding gangtool for citizen L16 back tool
By mkmk123 in forum CNC Swiss Screw MachinesReplies: 4Last Post: 07-07-2008, 02:39 PM -
Citizen tool pre-setter
By yoopertool in forum CNC Swiss Screw MachinesReplies: 13Last Post: 09-18-2007, 12:54 PM
Posting Permissions
