Hi everybody. Prompt please how it is possible to solve this problem. I use Motenc-Lite PCI board. My problem: it is necessary to configure axis X and axis R (A) as master and slave for gantry milling machine.I had a whack at the problem also has made the following: In core. HAL file I have substituted trivkins on gantrykins and have written:
net Xpos-cmd axis.0.motor-pos-cmd => pid.0.command => pid.3.command
net Ypos-cmd axis.1.motor-pos-cmd => pid.1.command
net Zpos-cmd axis.2.motor-pos-cmd => pid.2.command
Motors start rotation, then there is an error:
joint 3 following error and motors stop. I shall be grateful to all answered.
P.S. All HAL has attached
Results 1 to 1 of 1
-
07-03-2010, 08:56 PM #1
Registered
- Join Date
- Jul 2010
- Posts
- 0
Master and Slave axes in EMC2+Montec
Reply With QuoteSimilar Threads
-
to slave or not to slave
By stef_d in forum DIY CNC Router Table MachinesReplies: 4Last Post: 11-27-2009, 06:52 PM -
Slave Axes in TuroCNC?
By MGeo in forum CNC (Mill / Lathe) Control Software (NC)Replies: 1Last Post: 02-17-2008, 02:09 PM -
Master Slave Trolley Arangements?
By technomage in forum Linear and Rotary MotionReplies: 0Last Post: 05-23-2007, 10:36 PM -
master-slave servos
By js412000 in forum Servo Motors / DrivesReplies: 4Last Post: 03-09-2007, 07:36 AM -
Master and Slave servo
By Builder in forum Servo Motors / DrivesReplies: 3Last Post: 11-02-2004, 03:55 PM
Posting Permissions
