For the folks who already converted their G0704 to cnc and replaced the stock motor controller with a KBMM125.
Did you re-use the other stock electronics?
If so, do you have an existing thread of how you integrated the KBMM125 back into the stock electronics/housing?
I have the Kbmm-125 running on the bench with a Weiss 1.1kw motor.
The stock motor controller seems to have few less wires hooked up which is throwing me off as a simple swap out.
1st question. Can the factory switch that controls spindle direction Fwd/Rev/Neutral be re-used?
2nd question: Can the factory Pot be used instead of the external one that came with the KBMM-125 board?
I'm not advanced enough yet in my CNc conversion to control spindle via Mach3 and wanted to retain the switch until then.