Originally Posted by
ger21
The g-code says it's for a .125" tool? If so, the pocket will only be 2.25".
The g-code has the toolpaths at 2.125. Add the radius twice, and you get 2.25"
It's centered on the Y axis, but 1/16" left on the X axis. X min = -1.125, X max = 1.
So, if it's the wrong size, then you probably have your steps/unit in motor tuning wrong. Just make sure you don't have any axis scaling enabled.
Not sure on the off center part. Get it the right size first, then we'll go from there.