I don’t know how I will go here but hopefully someone may have an answer. I have a good quality bench grinder specs are 1 HP, 415V 3 phase, 2800 RPM, 1.5 Amps.
Can this unit be run directly off 220V 3 phase without damaging it?
If not can it be converted from 415V to 220V, noting that there are only 3 wires coming out of the motor casing, if it can only be run at 415V in this configuration is it possible to make a change internally to allow rewiring to 220V? If so I would pass it to specialist motor rewinder to do this.
Thanks
Cam