Can anyone help me figure out how to setup my stepper motors? I just can't seem to get it. I have a dyna mechatronics dm2800 using mach3 with ess. What I have here is right out of the dyna manual. The ballscrew lead is 2.5mm. There is a belt reduction of 2.5:1 from it to the 200 steps per revolution of the stepper. This gives a step resolution of 0.0025mm. I went into and tried to tune the motors using an indicator. I set the indicator at like .03 on the z axes and went into mdi and raised z .025 it only moved a couple of thou. I just keep doing this until I got it to move .025. I went in and moved it 1.0. I didn't check it with indicator but it looks like it's moving an inch. The problem is in the steps I have is 47775 this seems really high. I haven't seen anything on line that high and I looked at a lot of sights on how to do this. Another thing is the frequency. Most of what I saw and read they are set at 32,or 64, mine is set at 256 and the motors sound good This is what it was set at I did not put that in there. I'm really at a loss can anybody help me out? Thank you for any help
Mike B