Effect of T0 (tool offset cancel)
In Camsoft CNCProfessional v14.7, when a lathe tool call is made, the current Horz and Vert offset amounts can be seen to be implemented immediately on the axis displays. This is fine by me.
Now, to undo that effect, a T0 in the program works perfectly, that is the displays revert back to the axis positions with no offsets applied.
My question is this: is it possible to mimic the effect of the T0 command within a logical statement of some sort, other than actually keying it in, in mdi?
In a similar vein, is there a way to force the Axes Displays into absolute display mode via a logical command? I wish to ensure that when using the READOUT command, that the proper axis display mode is in use.
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)