CNC 88HS control.
Is there a way in programming to slow down the rapid move to 50%?
I'm running a part that has one hole that is .200" diameter x 4.169" deep in SS. I have to overide the rapid feed rate for this hole, the drill doesn't like going in 100% rapid. Once that drill is done I have to ramp it back up to 100% rapid. I really don't want to babysit this part while it is running.
I'm using a G83 to drill the hole, should I be using one of the other drill cycles? I definitely need to clear the chips, so I have to come out of the hole.
Thanks,
Don