Hi all,
I set up my router with two stepper motors on the X axis. I set up separate home switches so that mach3 would square up the gantry.
Everything works perfectly so far.
Now I wanted to correct the last 1mm (over 1m) by setting Home Off. to 1mm on the slaved "A" axis. I expected the gantry would move to one off the switches triggered, then backoff by the Home Off. length. Then the other would do the same.
However it looks like the "A" axis Home Off. is ignored if the axis is slaved.
Is there anyway to adjust the squareness electronically, or must it be done mechanically?