I have 3 425oz motors and 3 5042 drivers with 1 36v power supply. i am a little confused about the connections on the drivers. i have a motor connected to the driver with no problem. i have 1 wire connected from the driver to the breakout board. that is about all i can under stand from the wireing diagram located here http://www.kelinginc.net/KL-5042wiring.pdf. i am not sure what the box is called that is to the right and just below the breakout board that has a "- + 5 volt" in it. also how do i connect multiple wires to 1 slot on the beakout board? Any idea?
Jim