Hello all! I've put together my Procut CNC 3x3 table w/ water table and I've setup my G540 and PC and I'm learning the Mach3 and BobCAD software.
The debate still remains on where to locate the table. It's currently in the basement just for testing/learning purposes (no cutting taking place). But I am considering setting up shop down there.
Here are my options:
1. In the basement (15' x 16'), closed in with large CFM exhaust fan for good negative press (dust and fume control). Sealed off with insulation and plastic. The compressor would be in the garage. The corner where the table would go is surrounded by concrete walls. I have a water table as well.
2. Build a shop (12' x 20'), wood floor on slab (slab preferred). Insulated for all season use. Significantly more costly than setting up shop in basement.
Concerns:
My biggest concern with the basement are safety hazards like fire and fumes. I have a baby girl and wife and clearly want no harm or discomfort to them. That is paramount.
Basement safety countermeasures:
My idea for making the basement a safe place to operate is good ventilation out the side of the house, and sealing off the basement with insulation and 4 mil plastic sheet.
My big questions:
How many of you are operating plasma cutters (CNC or not) in your basement safely? And what issues/concerns arise from doing so? Smell? Noise?
Note:
I will be cutting aluminum 90% of the time and have a water table. I know this raises concerns of hydrogen gases and other fumes, perhaps?