[machinehop5]

not to muddy the water even more are you sure you have the VFD wired up correctly and the dip switches correct on the VFD.

,,,yes, good point. The Encoder cable should be plug in to J5 plug on the 1010-4 PCB and the Spindle must be set for Closed Loop Vector Control.

call these guys for more help https://nxgenparts.com/ele-electronics/fadal-ele-0025/

[ballistic42]

,,,yes, good point. The Encoder cable should be plug in to J5 plug on the 1010-4 PCB and the Spindle must be set for Closed Loop Vector Control.

call these guys for more help https://nxgenparts.com/ele-electronics/fadal-ele-0025/

Here is an old post might want to look at this.

https://www.cnczone.com/forums/fadal/93675-error-10-motor-overload.html

[ballistic42]

Here is an old post might want to look at this.

https://www.cnczone.com/forums/fadal/93675-error-10-motor-overload.html

Found more info

https://nxgenparts.com/content/Quick%20Reference/Error_Codes.pdf

I would check all this before dropping coin on boards.

[Jeremy_Sawatzky]

...the manual for your Yaskawa F7 looks like A1-02 Setting should be 3 for Vector Control

Just checked and it is set for (3) Flux Vector.



I have also checked all of the error codes, the best idea I have is that I am simply not getting the software "GO" signal that I need. Then when the control doesn't see any movement it throws the #10 Motor Overload error even though nothing is actually overloading.

[ballistic42]

Your ATC works with no issues right? The Spindle Orient works like it should?



QUOTE=Jeremy_Sawatzky;2530970]Just checked and it is set for (3) Flux Vector.



I have also checked all of the error codes, the best idea I have is that I am simply not getting the software "GO" signal that I need. Then when the control doesn't see any movement it throws the #10 Motor Overload error even though nothing is actually overloading.[/QUOTE]

[Jeremy_Sawatzky]

[QUOTE=ballistic42;2530972]Your ATC works with no issues right? The Spindle Orient works like it should?

Yes it all works as it should