Hi everyone
Recently we had a customer has a problem with his laser:
When he cut anything with rounded corners or circles the laser will not line up. See below photo.
Attachment 237940
we tried to help him solve the problem by following steps:
This fault should be caused by X-axis out of plumb with Y-axis.
Please check the gears of Y-axis like below pictures, just pull the belt and check if the gears are loosen or not,
if yes, please fix them. and test your machine again.
Attachment 237944
If still not ok, please cut a square with 150x150mm size, and measure the two diagonal lines are equal or not,
Attachment 237946
If they are not equal and even more than 0.5mm D-value,
then we have to readjust the X-axis and Y-axis mechanical part to make them vertical.
Attachment 237952
If the belt/gear are tight enough, or the fault still there after fixed, or the gears are not able to be fixed.
if anyone has any suggestion for these steps or for other possibilities,
please give us advice,
thanks in advance.
and for more troubleshooting lessons:
Troubleshooting List