[forhire]

I'm stumped. Program protect key is off. I have old values in the OFFSET / WEAR screen from the previous owner. I cannot enter or change any values except T (tool tip). I have tried X/Z and U/W but the values don't input. I cannot enter R (radius) either. It's as if it's locked somehow.

I key in "X 0.0 INPUT" but the last digit simply remains flashing and doesn't change.

Any ideas?

[forhire]

Well I feel dumb. I have it sorted. Turns out I cannot enter zero. The 0T-A does use U/W for input and the numbers must be NONZERO. I suppose it is due to the additive nature of the table.

So for example, tool 5 had an X wear offset of -0.0045, to clear it I have to key in: U 0.0045 INPUT.