587,172 active members*
3,105 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Visual Mill > Help for a new user

Thread: Help for a new user

Results 1 to 3 of 3
  1. 09-19-2005, 07:18 PM #1
    debutpic
    debutpic is offline Registered
    Join Date
    May 2005
    Posts
    10

    Help for a new user

    hello all

    I continue my appprentissage
    I have a part with two reaming of 20 mm
    diameter and 5 mm of depth
    I make two operation of machining

    1) Surfacing -1mm
    2) Reaming

    how to configure the parameters of the operation
    reaming so that the machining of the hole starts in top of the part
    -1 mm
    Attached Thumbnails Attached Thumbnails ex4.jpg  
    Reply With Quote Reply With Quote
  2. 09-27-2005, 03:11 PM #2
    sailandoar
    sailandoar is offline Registered
    Join Date
    Sep 2004
    Posts
    35

    Visual Mill Training Material

    Mecsoft website has expanded it's training material available online. Several vidos and PDF's of the user manauls.
    Good Luck,
    George Ray
    Reply With Quote Reply With Quote
  3. 10-04-2005, 05:18 PM #3
    chmillman
    chmillman is offline Registered
    Join Date
    Sep 2004
    Posts
    264
    The easiest is probably just to copy the reaming curves and move them down 1mm (Copy, paste, move). Then use the copied curves for the reaming op. VM doesn't have fantastic tools for working with contours (curves) at different depths than where they are drawn, the only other solution I have found is to get out your calculator. --ch
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules