I'm trying to do a simple contour in a shaft to make splines, and when i use transform to rotate the path around the shaft, then post the code I get a new work cord for every position. What am I doing wrong? See attached files. On x5
I'm trying to do a simple contour in a shaft to make splines, and when i use transform to rotate the path around the shaft, then post the code I get a new work cord for every position. What am I doing wrong? See attached files. On x5
WANNA GO FASTER
I can't open X5 file. But, I bet when you used transform, you checked the box that outputs a new coordinate for each transformation.
Set it to Maintain Source operations under Work offset numbering,review picture
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
Thank you cadcam. The one thing I didn't do was lock in the work offset to -1. I checked the box but left it at 0. Thanks again.
WANNA GO FASTER