[wantacnc]

I did try using a USB cable to the port on the break out board but mt lap top wouldnt find the port Using the newer software.

So with using 1605 ball screws I would need to go 2:1 gearing correct Mactec, I guess the servos run to fast?
Joe

[mactec54]

I did try using a USB cable to the port on the break out board but mt lap top wouldnt find the port Using the newer software.

So with using 1605 ball screws I would need to go 2:1 gearing correct Mactec, I guess the servos run to fast?
Joe

No the USB port on the Breakout Board is for a optional 5v Power supply only

No they would not run to fast the Gearing is required so you have enough power to move your X and Y axes

[Jim Dawson]

I did try using a USB cable to the port on the break out board but mt lap top wouldnt find the port Using the newer software.

Joe

The USB cable supplied by DMM connects between the laptop and the drive. It is a USB serial port adapter interface.

[wantacnc]

Does anyone have a DYN Servo Drive USB Tuning Cable CA-MTUSB-FR1 they want to sell? Shows to have at DMM in canada but anything shipping across the border can take months. Beg borrow so I can get my stuff running, Let me know.
Joe in St. Louis MO.

[Jim Dawson]

I normally get stuff from them in 2 or 3 days. With ground shipping.

[wantacnc]

Jim has that been within the past 4 months? Delivery in the USA?
I have heard otherwise from friends waiting on parts / material from Canada. Thats why asking to borrow, Buy a cable from out of USA, Just wanting to make sure all is well with the set up as The mill is shipping to me and I dont want to make conversion parts to retro the mill to the DMM if no good. I hope you see my point