Hello all, I am considering using EMC to controll my Bridgeport. I am going to be doing a PC based software conversion to replace my old DOS controller. I was going to use Mach3 but have recently been told that my servo drives need PWM inputs and that Mach only has step and direction outputs. I was planning on using a Pico systems controller that uses PWM and John from Pico says his board works perfectly with EMC. I don't have any Linux experience at all, never used it. How do you like EMC? What are the pros and cons of the software? If you have used Mach3 and EMC, which do you like better? Is it user friendly?
Thanks.
Scott