ok, after programming the pic am keen to get a motor turning, but its not happining.
One thing I find strange is that if I meter pin 14 of the PIC am not reading any voltage?? but if I meter where the 5v comes into the board on the leg of the 10K resistor I get 5V but on the other side of the resistor towards the PIC I get 0v.
I have metered from the PIN14 to the input pin and read 10k indicating continuity, so why no 5v reading?
Also I scoped the pins 15&16 I dont see any wave forms from timing resonator, should I or would it be to fast for me to see?