[johnmckeown]

Hi
I have just purchased a used mycenter 0. 1998 i had one years ago but i can not remember how to start up. I power on then hit the on button again and the servos power up now how do i home axis. i am familiar with the control but cant remember sequence, its been about 10 years. it has a yasnac i80.

thanks john

[AngryGuy]

Is that a series 11 control? The mycenter I ran was a series 11. Put it in jog and move all axis away from the home position minimum 30 mm. Turn on zreo return and jog them back toward home. It will stop on it's own when it gets to zero. If you let go before it does you'll have to do that axis again.

I used one where you had to jog it off and one where I could just turn on the zero return and just hold the joystick away from home, it would reverse on it's own. It's been so long I shouldn't even be answering this.