[gun_mike]

I've recently ordered xylotex 3 axis board to control my hommade mill, Ive downloaded mach2 and would like to configure it to my machine. The problem is I dont know where to start.
Ive read over the xylotex setup files
But i have no idea how to hook up the board to the software
the xylotex pinsetup?? is this

(board)...... (PP)....... (db25 pin#)
step x ........PD0 ........2
dir x ..........PD1 .........3
step y ........PD2 ........4
dir y ..........PD3 ........5
step z ........PD4 ........6
dir z ..........PD5 .........7
GND ..........GND .........18,19,20,21,22,23,24,25

db25 Is the cable that connects the board to a PP cable

thanks for any help
mike

[ger21]

Watch the video tutorials at www.machsupport.com The first one goes into setting up Mach3, which is similar to Mach2. I'd recommend going to Mach3 and not bothering with Mach2, btw.