Originally Posted by
Ydna
You have a personal score to settle or something? I'm trying to figure out why somebody that apparently has so many questions about the fundamental machine design choices of a Haas CNC doesn't just call up the factory and ask the people responsible, rather than trying to passive-aggressively pick a fight with Ken over the internet.
The Edster is just a former Haas owner, at least he says he used to own one, who goes from Haas post to Haas post to cause problems and stir up trouble. You can check his posts to verify this. In another Haas post yesterday on another forum, he responded to someone by telling them basically that they were ignorant by telling them that "I guess ignorance is bliss.......... " I just assumed that he was speaking from personal experience and so I did not respond.
Mike
Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28