Since you already have the xp running I would take a hard look at the Mach2 software at www.artofcnc.ca This is pretty powerful 6axis controller that has most of the bells and whistles and it is only around $150 USD. If you aree going to micro step you will need drivers capable of that. If you are going full or half step email me as I have some stuff I am getting ready to sell. My email
address is: [email protected] Take the capital X's out since I am trying to cut down on my amount of Spam intake!!! (wedge)
turmite
No greater love can a man have than this, that he give his life for a friend.