I know this site is more related to CNC than automation/control but since Im a member here I figured it might not be a bad place to ask about PLC's too.
Do any of you know of a hobby version of a ladder logic type program for programming PLC's? The version the high school I went to uses is around $500 or so - too expensive for me.
Any ideas?
Steve
Thread: PLC programs?
Results 1 to 2 of 2
-
05-10-2007, 04:20 AM #1
Registered
- Join Date
- Dec 2005
- Posts
- 11
PLC programs?
-
05-10-2007, 05:06 AM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24220
As you may know, PLC software is Manufacturer specific, and most charge for the s/w, many who want to get in cheap use Automation Direct http://www.aboutplcs.com/directlogic/software/
I haven't used their product but apparently its a low cost way to get in to PLC.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Similar Threads
-
CAD programs
By Crazycorkey in forum Uncategorised CAM DiscussionReplies: 3Last Post: 02-11-2007, 01:21 AM -
DNC Programs
By zoeper in forum CNC (Mill / Lathe) Control Software (NC)Replies: 3Last Post: 01-12-2007, 10:48 PM -
sub programs
By southernexplore in forum Mach MillReplies: 4Last Post: 11-19-2006, 10:13 PM -
What programs can do this-
By july_favre in forum Uncategorised CAM DiscussionReplies: 19Last Post: 09-23-2005, 05:36 AM -
Which programs do you use ?
By bunalmis in forum DIY CNC Router Table MachinesReplies: 23Last Post: 07-25-2003, 03:02 PM
Posting Permissions
