Hi there,
assume my post processor output Gcode (tool-path command) as below:
(1)@start_of_file ==>
(0)@vmid_info ==>
(1)@def_tool ==>
(1)@plane_data ==>
(1)@absolute_mode ==>
(1)@start_program ==>
my question is : what decides the output sequence of these the tool-path command ?
why @absolute_mode is output after @def_tool ?
SOLIDCAM, the software itself sets it and I can't change ? or I can control it by setting post processor ?
thanks for reading,
If this issue could be find in GPPTool User Guide , please tell me , thank you!