Hi all..........
thought I'd up load some project photos......and for my electronics hardware I used the Smooth Stepper from Warp9 Warp9 Tech. Design - Home of the SmoothStepper - Home because the PC running Mach3 doesn’t have any parallel ports, and the C32 bob from CNC4PC CNC4PC and I must admit jeez I can't complain runs like a dream, had a few hiccups at the start but along with reading the threads here the experience gained from a self build is irreplaceable.
I used Aluminium 3inch box section and 6"X1/2" plate for the table setup simply because I've had it for nearly 10 years in the shed leftover from a job....and I used brass shaft to mount the ballnuts and again this was given to me from a mate who had it lying around his shop floor... and for those of you who never worked on brass beware the dam stuff sprays tiny sharp needles EVERYWHERE ha my fingers were like small cactus
More photos to follow.....