I have finally completed my CNC Machine. I am using KCAm as the software and when I setup the timing the max IPM I get 3. I have the following hardware:
Slo-Syn M09-FD08 Rated @ 3volts 4 amps 200 oz torque and 200 steps
per rotation. The motors are 6 wire but currently have them configured as 4 wire. Each pair of leads measures 2.1-2.8 ohms.
I am using 5/16 all thread for all 3 axis which I have measured and get 18 full rotations per inch.
24 VDC Twin FLy P1-150-24
Xylotex 3 Axis board with the VREFs at 2.98volts
KCam Software.
Computer is a P2 733
Cutting size is 33" by 22"
What am I doing wrong to only get 3 IPM?