588,191 active members*
7,930 visitors online*
Register for free
Login

Thread: Micronor MR175 Handheld Pendant

Results 1 to 3 of 3
  1. 10-15-2006, 07:27 AM #1
    Wm McNett
    Wm McNett is offline Registered
    Join Date
    May 2005
    Posts
    35

    Micronor MR175 Handheld Pendant

    Does anyone have any info on the Micronor MR175 Handheld Pendant?
    http://www.micronor.ch/content/pdf/manual/mr175.pdf
    Attached Thumbnails Attached Thumbnails 490751.jpg  
    Reply With Quote Reply With Quote
  2. 10-15-2006, 08:00 AM #2
    Halfnutz
    Halfnutz is offline Registered
    Join Date
    Feb 2005
    Posts
    750
    It looks nice, but I dont think 100 pulses per revolution is enough on the MPG. I'd have to turn it 200 times to move my stepper sytem one inch, and 20 times (more or less) for the servo system I'm building. There may be an easy way to multiply it, I dont know. Definately something to check out.
    Halfnutz

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 05-09-2008, 03:59 AM #3
    awander
    awander is offline Registered
    Join Date
    Feb 2004
    Posts
    21
    Depending on your Conroller software, you should be able to tell it how far to move for each pulse from the MPG.

    You can do it with Mach3, I know for sure.

    Andy
    Andy
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules