588,655 active members*
6,242 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Tormach Personal CNC Mill > Reducing Spindle & Coolant dwell times

Thread: Reducing Spindle & Coolant dwell times

Results 1 to 2 of 2
  1. 07-20-2010, 05:21 AM #1
    WMD
    WMD is offline Registered
    Join Date
    Jun 2010
    Posts
    0

    Reducing Spindle & Coolant dwell times

    So I have my 770 all set up and running great, and have a lot of parts to run, and the m03 and m07 start delay is excessive.

    Does anyone know where to adjust the dwells for those macros?
    Reply With Quote Reply With Quote
  2. 07-20-2010, 07:03 AM #2
    flick
    flick is offline Registered
    Join Date
    Mar 2008
    Posts
    256
    m3.m1s. Play only with the '3' (baseline dwell) and the '3.5', which is additional dwell proportional to the commanded RPM, and works out to about 3.5 seconds at 4000 RPM.

    All standard disclaimers apply.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Spindle coolant what are you using?
    By carbidecraters in forum Fadal
    Replies: 3
    Last Post: 06-02-2012, 08:51 PM
  2. Balancing Main and Sub Spindle Cycle Times
    By danrudolph in forum CNC Swiss Screw Machines
    Replies: 2
    Last Post: 04-07-2009, 09:39 PM
  3. Coolant for HF Spindle ?
    By Greolt in forum DIY CNC Router Table Machines
    Replies: 0
    Last Post: 07-03-2008, 10:59 PM
  4. thru the spindle coolant?
    By cnc@52 in forum Haas Mills
    Replies: 4
    Last Post: 09-16-2007, 06:03 AM
  5. Through Spindle Coolant
    By Josh-PTP in forum Haas Mills
    Replies: 1
    Last Post: 02-28-2007, 06:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules