[jjproto]

Hi all,

I have a Shoda router with a Fanuc 11m control. I have been tasked to add an M function that will trigger a Miller Mig Welder. I have dug around in the cabinet, but would love some advice, and if you guys have wiring diagrams, photo's etc...that would be awsome.

[Al_The_Man]

Unfortunately you have to modify the ladder (PMC).
Unless you have an M function that is already programmed and not being used.
Al.

[garylfix]

look in the back of you electrical prints for a spare m code option or if you find one you will need to look for the m code answer also so the control will know tha t the m code is completed

[jjproto]

Thanks Al,
Do you know of any specific instructions or how to's for this process? My web searching has not been turning up much.

[Al_The_Man]

Traditionally Fanuc supplied a FAPT portable 'suitcase' computer that had the ability to write/edit the ladder and burn the eproms, the 10/11 commonly has a eprom cassette on one of the system cards, when the system boots up, it takes the ladder off the cassette and loads into memory before running the ladder.
I don't know if Fanuc has any PC based program for the 10/11.
Unfortunately they did not follow Mitsubishi's lead where you could edit and program on line.
When the part program sees a M,S,T code etc, it is passed over to the ladder for processing, as mentioned, if the M code needs confirmation, then the program halts until the process issues a FIN(ish) signal back to the CNC side.
Al.