[nybuxt]

On a recently purchased Mazak Slant 15 with Fanuc 6T-A controls I have run out of memory and can't finish writing my new program. Does anyone running one of these old machines know how to delete programs from the memory? I was going to order a operating manual from Fanuc but the earliest they can get it to me is July, does anyone have a copy?

Thanks,

Nyle

[angelw]

On a recently purchased Mazak Slant 15 with Fanuc 6T-A controls I have run out of memory and can't finish writing my new program. Does anyone running one of these old machines know how to delete programs from the memory? I was going to order a operating manual from Fanuc but the earliest they can get it to me is July, does anyone have a copy?

Thanks,

Nyle

Hi Nyle,
In Edit Mode, with Write Protect Off:

1. Press O (not Zero), and DELETE to delete the current on screen program

2. Press O followed by the program number, then DELETE to delete an existing program with that number, current on screen, or existing in memory.

3. Press O followed by -9999, then DELETE to delete all programs in memory.

Regards,

Bill

[nybuxt]

Thank you so much,
I have been racking my brain with this for 2 days now!