Good day all,
Nice clean forum. Well done!

My company bought Mastercam and Solidworks as a combination about a year ago. We have been using Mastercam on our mills (Anilam 3300 controllers) a little and have not played with the Lathe side yet.

We have Mastercam X but we are still working with 9.1 as this is what the new machinist we have here is comfortable with. One new thing at a time...

We have a couple old lathes here. A Hitachi Seiki 2 Axis with a 3T and Mori Seiki with a 6T.

Im looking for a good 3T post that is close to what I need and was wondering if one was out there. Same thing for the 6T eventually, but right now, one thing at a time.

Im having problems with the posts that come with Mastercam. The 3T control does not support G54, and the threading cycle alarms when loaded up with an NC file generated with the standard Fanuc post from MC.

Thanks for any help,

Andy Kveps