Hi there, everyone. I am a Biesse Rover A Ft processing centre operator (just an operator), and I have a question regarding the Biesse Editor. My technical english is very limited, don't really know the english terms for cnc/nesting activity, so I will try to describe my problem in detail.
During work, I am getting preset orders form technicians, wich I load in Biesse editor, set the Panel parameters and execute the Nesting, wich give me the resulting panels to be executed (Result). Here comes the problem. The nesting algorithm (or whatever that is) is organizing the pieces in a very unconvenient manner. For example, if I have like 10-20 very thin slats -among many other pieces - (2000x50 slats for example), in the resulting panel I will have them grouped together for execution, wich results that there will be too many cuts/mills in a very small area, so the router will eventually push them away due to loosing vaccum in that area. Result is spoiled piece, scrap, lots of them, practically I am loosing all pieces but the first. So I am trying to find a way to manually override the piece arrangement on the resulting panel after nesting has been generated (like puting one thin, then one bigger piece, then a thing again, for keeping the vacuum). My technicians and engineers have no clue about how to solve this issue. Question: is this possible to manually modify the resulting panel arrangement? If yes, then please give a very detailed description on how to do that (I am very new to this whole process, this is a new job I just fresh). Thanks for any input in advance, any advice will be greatly appreciated.