Let's say I create a box 2" X 2" and put a tool path to it using polar interpolation code, it should look something like this without the tool offest.
X2.0
C-1.
X-2.0
C1.0
X2.
But instead Esprit is outputting this: I've shown the gcode with long nc code in hopes of getting some help on this matter. I no longer have support and my company will not be upgrading for another few months...oh well. This post is from the legacy post file and I would think it should work.
1 Hard EX_STARTCODE %
O5323
(U)
2 Hard EX_MAINSTART
3 Hard EX_BEFORECYCLE
4 Hard EX_FIRSTTOOLCHANGE G28 U0 W0
T0600
N1 M01
G28 U0 W0
M41
T0606 G97 S3000 M04
G00 Z10. M08
X.2 Z1.
5 Hard EX_SETWORKCOOR
6 Hard EX_CYCLESTART(CntWrap) (rough contour)
7 Hard EX_CHANGEWORKSYSTEM(CntWrap)
8 Soft EX_RAPID(CntWrap) X2.8284 C315.
9 Soft EX_RAPID(CntWrap) Z.1
10 Hard EX_STARTPOINT(CntWrap)
11 Hard EX_FACEON(CntWrap) G112
12 Soft EX_FACESEG(CntWrap)
13 Soft EX_FACESEG(CntWrap) G01 G98 F18.
14 Soft EX_FACESEG(CntWrap)
15 Soft EX_FACESEG(CntWrap) X0 C1.4142
16 Soft EX_FACESEG(CntWrap)
17 Soft EX_FACESEG(CntWrap) X-2.8284 C0
18 Soft EX_FACESEG(CntWrap)
19 Soft EX_FACESEG(CntWrap) X0 C-1.4142
20 Soft EX_FACESEG(CntWrap)
21 Soft EX_FACESEG(CntWrap) X2.8284 C0
22 Soft EX_FACESEG(CntWrap)
23 Soft EX_FACESEG(CntWrap)
24 Hard EX_FACEOFF(CntWrap)
25 Hard EX_CYCLEEND(CntWrap)
26 Hard EX_TOOLCANCEL G113
G28 U0 W0
T0600
N2 M01
G28 U0 W0
M41
27 Hard EX_MAINEND
28 Hard EX_ENDCODE M09
G28 U0 W0
T0600
M30
Any help would be appreciated on helping me get this fixed.